The Manager30 Battery Management System

• Charges auxiliary batteries from the vehicle alternator while on the move
• It’s a 110 volt AC shore mains power charger
• An MPPT solar regulator
• A battery isolator
• A load disconnect controller
• Includes a remote battery monitor, making it market-leading

Input Voltage	110VAC/9-32VDC
Output Voltage	12VDC
Maximum Charging Voltage	16.0V* (*Calcium setting in storage mode)
Output Current Rating (Cont.)	30A
Country of Manufacture	Australia
Output Power	520w
Input Fuse Rating	50A
Output Fuse Rating	40A
Length (in)	17.5"
Width (in)	7.3"
Height (in)	3.1"
Warranty	2 Year
Weight (lb)	12.1
Protection	Overload, Surge, Reverse Polarity, Short Circuit

 

INSTRUCTION MANUAL

 

*A .PDF file viewer is required to view these files

Over the last three decades, our company has established a reputation as the power conversion specialists.

 

A 100% Australian-owned company, we have met the needs of customers in transport and other industries through exciting, innovative thinking.

 

We believe in total customer satisfaction and practice this by offering our customers:
• Technical advice free of jargon and free of charge
• Prompt turnaround of orders throughout Australia and globally
• Friendly, personalised, professional service and product support

 

In the unlikely event that a technical issue arises with a REDARC product, customers are encouraged to initially contact the REDARC Technical Support Team on the numbers below or email power@redarcelectronics.com for prompt and efficient diagnosis and product support.

Calling from	Dial
Canada	+1 (604) 260-5512
United States	+1 (704) 247-5150
Mexico	+52 (558) 526-2898

 

You can review REDARC's solar warranty terms or full warranty terms and conditions, which are also available in both French and Spanish if required.

 

Increased demands are placed on our vehicles with every passing mile. Many devices related to these demands - communications equipment, computers, measurement devices and precise actuators, are quite sensitive when it comes to the power they receive from the source.

 

However, power is not always clean and stable. At best it can cause poor performance or at worst cause damage to these devices. In a typical heavy vehicle setup there are a few major causes of electrical noise or instability. This includes:

• Vehicle charging and starting systems requiring the correct voltage to be applied
• Loads like compressor fridges, radios and water pumps causing short voltage drop
• High current consumers like engine starter motors or electric pumps causing electrical noise
• The vehicle alternator causing electrical noise, affecting sensitive devices

 

This can cause lights to be more dull or bright, inconsistent radio strength, fridge efficiency and performance dropping with voltage, inaccurate measurements being taken, and actuator speed and strength can suffer. Electrical noise can also cause excessive heat and interference resulting in damage to electronic components or internal batteries and poor performance during operation particularly on radio and measurement equipment.

 

The solution is a REDARC DC Power Supply, which can deal with a diverse range of noise and voltage levels. Whether it is a 12 or 24 volt vehicle running a 12 or a 24 volt appliance, requiring a clean and stable specific power supply, the DPS range will provide this power in even the harshest of environments.

 

With a range of power ratings you can make sure your vehicles safety, communications, and critical equipment always has the power to function effectively no matter how great the distance.