The MAXTRAX XTREME Mounting Pins are designed to work exclusively with MAXTRAX XTREME
Designed exclusively for MAXTRAX XTREME—these cannot be used with any other brands.
Does not work with MAXTRAX MKII See Additional Information..
Available with either 40mm or 17mm bolt size. 40mm and 17mm refers to the length of bolt used to mount the pins- both the 40mm and 17mm pins will hold either one or two sets of MAXTRAX
MaxTrax Xtreme Mounting Pin Set - by MaxTrax
- Designed primarily for MAXTRAX Xtreme Recovery Boards
- A set of 4 quick-release mounting pins to secure 1 or 2 pairs of MaxTrax recovery devices to the Recovery Device & Gear Holding Side Brackets - by Front Runner and other MaxTrax mounting systems.
- Made of black nylon and stainless steel.
- A set contains 4 stainless steel Nylock nuts and 4 stainless steel washers.
- Each mounting pin includes a hole to insert a small padlock (not included).
Weight: 3.5 oz (per pin) Dimensions: 12 x 10 x 2 in Size: 5.5 inches long including an
inch-and-a-half shaft of 10mm
diameter thread that can be cut
to length if required
Hardware: Yes, SS Nylock nuts & flat washers MAXTRAX Products purchased after January 1, 2017 from an authorized dealer in the United States come with a Lifetime Manufacturer’s Warranty against defects and faulty materials.
This Warranty is provided by MAXTRAX Australia and facilitated in the United States by Adventure Imports, LLC who holds no responsibility for the warranty.
This warranty is subject to the Limitations on Refunds/Replacements at Clause 3 below, if the Product/s, when used in accordance with the “Instructions for Use” provided with the Product/s, fails due to defective manufacture, we will replace the faulty product.
If the Product/s is found, upon inspection by us, to be defective and covered by our warranty, we will arrange for a replacement or refund (as applicable), normally within 7 working days of receipt of the Product/s (this may take longer in some cases if product is out of stock). MAXTRAX expressly excludes any liability for consequential loss, incidental or indirect damages (including but not limited to damages for loss of profits and business interruption) due to a defect of the Product/s. In particular any loss or damage caused to any equipment or accessories used with the Product/s or any loss resulting from a delay in repair or replacement are excluded to the extent permitted by law.
At our discretion, we may void the warranty if we deem the product has been used outside of its intended purpose for light-truck vehicles weighing under 7750LBS or 3500KGs. If the product has signs of excessive wheel spin that could have structurally damaged the product, we reserve the right to void the warranty. If the product has been modified in any way, shape, or form from the original manufacturer’s design, including drilling holes for mounting, or shortening the product, this warranty is void. Please see Clause 3 below for further details.
Under no circumstances does this warranty cover any damage caused by misuse due to wheel spin causing melted or broken “lugs” or “teeth”.- Please Note: Antiseize recommended on install
- Top roof rack manufacturers, including Rhino Rack, Eezi-Awn, Front Runner, and more, make a reciprocal bracket that allows for a bolt-on roof rack mounting solution
- Designed exclusively for MAXTRAX XTREME—these cannot be used with any other brands. Does not work with MAXTRAX MKII
- The design also permits a TSA-style padlock to be run through the top of the pin to keep your MAXTRAX secure—we recommend a bicycle cable lock if your security requirements exceed this
